Both are named for what they do rather than the tool underneath, the way Services is.
Old links and saved rail orders still land in the right place. The Go packages and their
endpoints keep their names, with a pointer in each to what the UI calls them.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
- hamlab install / uninstall (internal/setup): systemd or OpenRC, elevates through
sudo or doas, runs as the invoking user, sets or generates the password, names only
journal groups that exist, waits for /healthz, reports an active firewalld/ufw.
--purge and the data chown never touch a directory that isn't Ham Lab's alone.
- install.sh: curl-able bootstrap (arch detection, SHA256SUMS, offline beside the
binaries, noexec /tmp fallback). make release builds dist/ for amd64, arm64, arm
(ARMv6), 386, riscv64. Every build is CGO_ENABLED=0; the native one used to link glibc.
- internal/priv replaces every literal `sudo -n`: uid 0, sudo or doas.
- Updates acts on dnf, zypper, pacman and apk as well as apt; dnf shows installed versions.
- Services falls back to the plain systemctl table before systemd 246 and says so on
hosts without systemd. Disks falls back to /sys/block without lsblk.
- Listener binds with IP_FREEBIND, so a LAN address that isn't up at boot is no failure.
- Self-update: the new build must pass `check` against the live config, is put in
place by atomic rename, and the daemon re-execs itself (same under any supervisor).
- State and config writes are fsynced; a corrupt state.json is set aside, not fatal.
- Terminal shutdown no longer empties the saved list, so names come back after a
restart by design rather than by winning a race.
- Config default is ~/.config/hamlab; an existing ~/apps/hamlab is still found.
Co-Authored-By: Claude Fable 5.1 <noreply@anthropic.com>
